Big thanks to Mike today for hooking me up with the tune. Using the 3.625 pulley we came out @ 400HP / 420TQ with a steady 9lbs of boost. I need to do the IAT relocation and switch pulleys to the smaller one but that will come later. I wanted to be conservative to start rather than push the ragged edge.

The car pulled hard on the dyno with the torque coming on strong. Will see at the track if a rear gear change is needed with the 4.10's. The pulls were consistent with the boost. Fuel pump duty cycle never went above 45% so plenty of left.

I am very satisfied with how it drove and did today.

Great job again Mike!!!!