More to follow soon.
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
New spacer
Sent from my Z965 using Tapatalk
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
Had to weld a bung onto the radiator for the water temp sending unit.
Sent from my Z965 using Tapatalk
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
Do you run a thermostat?
Nice! You running that under the nitrous plate or are you planning on running a fogger?
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
There is no thermostat housing on this intake, each water jacket is ran with a -12 braided line. I can always install restrictors if needed.
Sent from my Z965 using Tapatalk
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
Either way, it sure looks good!!
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
This thing has been sitting way to long!!! You have to be almost ready to make some passes!!!
Whats left?
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
I've ran into a couple issues, hopefully be able to soon.
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
You're gonna miss out on some good weather coming up!!!
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
Should've tried some flex seal!!!
Sucks though that it had to come back out to fix one small problem. Nothing is ever easy.
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
It was a bad leak, not sure anything would have helped other than replacing it. It was inevitable, it was easier to just fix it now. Just typing about makes it sounds easy, but when your car is only inches off of the concrete floor, it's another whole story. It should be out soon though.
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
Had some throttle linkage issues as well, I hope this helps. I couldn't get the throttle past 3/4 of the way, this will raise the point at which it was able to mount before. It also gives me a little more travel on the throttle, time will tell.
Sent from my Z965 using Tapatalk
#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
There are currently 1 users browsing this thread. (0 members and 1 guests)