Got some work done in the garage this weekend.


Getting all this to work together should be fun.


Found an old Ford wiring book for the 84 Mustang, so its going to be a huge help.


Ill have to figure out the Speed sensor to Tremec, so that the Speedo actually works.


I removed the dash so that I could run wires and hook up connectors easier.





Notice the custom, one off, Hyd clutch pedal assembly.




Started running the wires


Once I get the ECM mounted, all this will clean up.


Mounted the fuse block and re-used a factor grommet & Hole to run the "in Car" wires into the interior.



After a productive weekend, I now have a list of needed parts to get ordered up. Hopefully that small glimmer, is the light at the end of this tunnel...