One of those weekends of work where you get a lot done, but it doesnt look like you accomplished anything.

Im 99% sure that Im finished under here. Ill know more once I fire it up.


I was going to use Dakota Digitals adapter, but I would have lost gauges while tuning. So I decided to use the supplied sensors.
I drilled and tapped the factory water neck (1/8 npt)


and then installed the H2O temp sensor.


The factory oil press sensor is a 1/4 npt, so I had to use an adapter.


The Ford Control Pack does not require an oil pressure reading to run, so I installed the DD sensor in the factory location.


Once those wires were run into the interior, it was time to figure out what wires I will need to make it all work together.







Its getting close, but I still have quite a bit to do.