#9 2011 Spring Street Car Shoutout
1991 Mini Tubed Mustang Coupe, in the works.
351W base, PG, Stock Suspension chassis
My goals for 2020 are:
1. New intercooler / radiator / trans cooler along with a welded charge pipe to TB and a bit of hot side / cold side piping redo after an AC delete - in progress now .
2. Rebuild of trans with more and better clutches for forward/reverse since on the transbrake this year and an upgrade of the direct drum along with changing torque converter to a non lockup 258mm unit - in progress
3. Installing a Holley Terminator X Max and 7" digital dash to run the engine and boost control
See what 1 - 3 yields me for the 1st half of race season till the taxes come back the full out on the motor build. The ultimate goal is to be:
1. Low 9's (9.30 or lower) with a build motor and 18 to 22 psi
Going to try and go south to make some passes once 1 & 2 above are done to see what the stock motor and about 11.5psi on the factory ECU get's me. Would love to see a sub 10.30x run at that level.
Switching from racing NMRA to OSCA (Outlaw Street Car Assocation) - closer races and better payouts. They have a race a Kil Kare this year on August 8th.
Will make the Dozen Shootout with my duck.
LS Swapped - Locally hated now
Just enjoy being back in a fox and able to cruise it some. Might see what it has at the track too! Then see where I need to go with it. I unfortunately do not qualify for the dozen though
250 straight six out of a dump truck and a munci rock crusher
I’m just hoping to make more than one pass this year. As soon as my pistons come in my collection of parts is going to the machine shop for a sleeves short locks that wasn’t in the plans for this winter. After the new engine get installed and broken in I’m going to swap out the spec clutch for a Mcloud RXT then a Edelbrock TVS.
They who can give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety. - Ben Franklin
1998 Mustang GT
Coyote Swapped
Dang, stick/coyote/tvs will be a handful!
Yes sir , my dealership is saying probably a may or June delivery
87 T-Top gt(sold)
93 Cobra (blk/grey)(sold)
96 Cobra (blk/blk)(sold)
93 Gt(put out to pasture)
93 Cobra #4084(sold)
2010 kona blue gt(sold)
2013 ghig gt
2018 kona blue gt
1) Install the On3 turbo kit and Microsquirt on the 89 GT.
2) Learn how to tune a Microsquirt car
3) Try not to blow it up
Should be a fun car. What size trubo did you go with?
Not bashing the Microsquirt but you might want to consider the Terminator X for the Foxbody, pretty nice unit with a ton of features, only thing I wish it had was the ability to drive low impedance injecotrs. https://www.holley.com/products/fuel...parts/550-937F
I beleive NXcoupe (Mike) is a dealer for them.
Greg
Midnight Mafia
There are currently 3 users browsing this thread. (0 members and 3 guests)