Stock K member is out, pilot bearing replaced, rear main seal replace and oil pan gasket replaced. One piece I've been stuck on is this bellhousing bolt that's broken off in the block. I attempted to weld a nut to the bolt by building up some slag on the broken off bolt and welding a nut to it, but the slag isn't enough close to being strong enough to holding while I try to turn the nut once it's welded on. It just breaks off immediately with minimal effort.


Another fun issue I've found. This is the harness from the battery to the block. You can also see someone added the black cable with orange tracer goes from the motor mount bolt to the inner frame rail.