The other thing that was bugging the crap out of me was the placement of the anti roll bar. The damn thing hit the upper control arms just driving through the pits and unloading off the trailer. It also banged hard on launch. I cut that bitch out of there! I used my new plasma cutter and it cut like butter, a little too well. But I got it all ground down, and plated over them with my new welder. You can see the arms are bent from the upper control arm pulling apart 2 years ago, I tried straightening them out as best I could, but to no avail. New one is on order from UPR care of Sharad Radiris, who helped me out big time with a weld your own kit.
Thanks to my wonderful wife for getting me the new welder for Christmas last year! I ended up with a couple holes in the frame rails, but not a big deal.
I removed the upper CA and the coil overs as well to gain access to do all this.
Reply With Quote